F250 rear pinion nut torque. Any help with this problem would be greatly appreciated.

F250 rear pinion nut torque. The only specs I have for a Dana 80 are for what the bearing preload should be. Ring and Pinion Gear Set Up To install your ring and pinion gears and/or differential correctly, it is critical to torque your bolts and set your preload and backlash correctly. When replacing the pinion seal on a 2008 F250 4x4, torque the pinion nut to the manufacturer’s spec, typically around 250-300 ft-lbs. Detailed torque specifications for the Ford Super Duty 4, made from (2017-on), and tightening torques for all of its components, including the wheels, engine, brakes, suspension, and exhaust, in both Nm and ft/lbs. I've never changed a pinion seal before without the rest of the differential apart. May 25, 2023 · 1) with all the guts of the differential removed, insert pinion gear from the rear with bearing and crush washer on it 2) On the other side, install pinion yoke with bearing and torque until you reach the pinion nut torque spec 3) tighten slowly and keep testing until it takes the set amount of in/lbs (16 - 29) to spin the assembly. Dec 8, 2010 · Does anyone know the Pinion nut torque spec for the 2002 F350 SRW with the 10. My question is what is the torque spec for the pinion nut. You tighten that until you achieve the desired bearing preload as measured by a spinning torque reading. Use a torque wrench to apply the specified torque—typically around 250-300 ft-lbs—but always verify with a service manual. gp uesu3e bsvllzq as2 j5x jqwt dkkve wa 5a0md5g 0fhql